ZyXEL Communications PMG5317-T20A - Page 214

Chapter 20 Voice
PMG5317-T20A User’s Guide
214
Each field is described in the following table.
Table 91 VoIP > SIP > SIP Service Provider > Add New Provider/Edit
LABEL DESCRIPTION
SIP Service Provider Selection
Service
Provider
Selection
Select the SIP service provider profile you want to use for the SIP account you configure in
this screen. If you change this field, the screen automatically refreshes.
General
SIP Service
Provider
Select this to enable the SIP service provider.
SIP Service
Provider Name
Enter the name of your SIP service provider.
SIP Local Port Enter the GPON Device’s listening port number, if your VoIP service provider gave you one.
Otherwise, keep the default value.
SIP Proxy
Server Address
Enter the IP address or domain name of the SIP server provided by your VoIP service
provider. You can use up to 95 printable ASCII characters. It does not matter whether the
SIP server is a proxy, redirect or register server.
SIP Proxy
Server Port
Enter the SIP server’s listening port number, if your VoIP service provider gave you one.
Otherwise, keep the default value.
SIP REGISTRAR
Server Address
Enter the IP address or domain name of the SIP register server, if your VoIP service provider
gave you one. Otherwise, enter the same address you entered in the SIP Server Address
field. You can use up to 95 printable ASCII characters.
SIP REGISTRAR
Server Port
Enter the SIP register server’s listening port number, if your VoIP service provider gave you
one. Otherwise, enter the same port number you entered in the SIP Server Port field.
SIP Service
Domain
Enter the SIP service domain name. In the full SIP URI, this is the part after the @ symbol.
You can use up to 127 printable ASCII Extended set characters.
RFC Support
PRACK (RFC
3262, Require:
100rel)
PRACK (RFC 3262) defines a mechanism to provide reliable transmission of SIP provisional
response messages, which convey information on the processing progress of the request.
This uses the option tag 100rel and the Provisional Response ACKnowledgement (PRACK)
method.
Select this to have the peer device require the option tag 100rel to send provisional
responses reliably.
VoIP IOP Flags Select the VoIP inter-operability settings you want to activate.
Replace dial
digit '#' to
'%23' in SIP
messages
Replace a dial digit “#” with “%23” in the INVITE messages.
Remove the
'Route' header
in SIP
messages
Remove the 'Route' header in SIP packets.
Bound Interface Name
Bound
Interface Name
If you select Any_WAN, the GPON Device automatically activates the VoIP service when
any WAN connection is up.
If you select MultiWAN, you also need to select two or more pre-configured WAN interfaces
that you set up in Network Setting > Broadband > Add New WAN Interface
. The VoIP
service is activated only when one of the selected WAN connections is up.
Outbound Proxy