Chapter 23 VoIP Status
PMG5317-T20A User’s Guide
241
URI This field displays the account number and service domain of the SIP account, which is used
to identify the SIP account on the SIP server. You can change these in the VoIP > SIP >
SIP Service Provider > Edit > SIP Service Domain and VoIP > SIP > SIP Account >
Edit > SIP Account Number.
Message
Waiting
This field indicates whether or not (Yes or No is displayed here, respectively) there are any
new voice messages leaving on the SIP server and waiting to be read. You have to enable
the MWI function in the VoIP >SIP > SIP Account > Edit > Enable MWI, and the SIP
server should also support the voice mailbox function.
Last Incoming
Number
Regardless of the status of the incoming call to this local SIP account, this field will display
the SIP account number of the remote peer at the last incoming VoIP call.
Last Outgoing
Number
Regardless of the status of the outgoing call, this field will display the last phone number
you dialed to make an outgoing VoIP call via this SIP account,
Note: The dialed number is recorded in this field only during the outgoing (SIP-based) call
setup signaling procedure. If you dial numbers and on-hook quickly as well as making
the outgoing call before the outgoing (SIP-based) call signaling procedure starts, the
numbers you dial here will not be recorded.
Call Status (This table displays the status of all active and ongoing calls. If there are no active or ongoing
calls, this table will be blank.)
Account For the current VoIP call categorized as Outgoing Call or Incoming Call in the Call Type
field, this field displays the SIP account number used in the current VoIP call. For the
current VoIP call categorized as Internal Call, this field displays the local internal phone
number of the call-originating phone port.
Duration This field displays how long the current VoIP call has lasted.
Note: The time calculation starts from the beginning of the call setup signaling procedure,
rather than the moment when the call is successfully established.
Status This field displays the current call progress or call process state of the VoIP phone call.
Calling - This state is only associated with the call categorized as Outgoing Call or
Internal Call in the Call Type field. For the Outgoing Call, it means the SIP account has
issued a (SIP-based) call setup signal to the SIP server, tries to make an outgoing VoIP call
to the SIP account of remote peers. As for the Internal Call, it means the call-originating
local phone port has issued a (Internal and Non-SIP) call setup signal to other target local
phone ports, and the phones attached to the target local phone ports will be ringing.
Ringing - The state is only associated with the call categorized as Incoming Call in the
Call Type field. This state indicates that there is an incoming VoIP call setup signaling
coming to the SIP account, and the phone ports configured to receive the incoming call
from the SIP account will be ringing.
InCall - Whichever type is in the Call Type field, this state will indicate that the call setup
signaling procedure has finished, and thus the call has been successfully established. The
users of both peers can begin to converse on the phone.
OnHold - This state is only associated with the call categorized as Outgoing Call or
Incoming Call in the Call Type field. This state indicates that the current call is connecting
to the SIP account, and the remote peer is in the OnHold state. This situation happens
under the following two scenarios: (a) the remote peer put the call on hold, or (b) the local
user put the call on hold.
Table 110 System Monitor > VoIP Status (continued)
LABEL DESCRIPTION
To Next Page
Loading...
