Chapter 4 Tutorials
PMG5317-T20A User’s Guide
33
3 Enter the General and Account Information settings as provided above.
Choose the Encapsulation specified by your DSL service provider. For this example, the service
provider requires a username and password to establish Internet connection. Therefore, select
PPPoE as the WAN encapsulation type.
Set the IPv6/IPv4 Mode to IPv4 Only.
4 Enter the account information provided to you by your DSL service provider.
5 Configure this rule as your default Internet connection by selecting the Apply as Default Gateway
check box. Then select DNS as Static and enter the DNS server addresses provided to you, such as
192.168.5.2
(DNS server1)/192.168.5.1 (DNS server2).
6 Leave the rest of the fields to the default settings.
7 Click Apply to save your settings.
General
Name MyGPONConnect
Type GPON
Connection Mode Routing
Encapsulation PPPoE
IPv6/IPv4 Mode IPv4
Account Information
PPP User Name 1234@GPON-Ex.com
PPP Password ABCDEF!
PPPoE Service Name MyGPON
Static IP Address 192.168.1.32
Others Authentication Method: AUTO
PPPoE Passthrough: Disabled
NAT: Enabled
IGMP Multicast Proxy: Enabled
Apply as Default Gateway: Enabled
VLAN: Disabled
To Next Page
Loading...
