Chapter 7 Wireless
PMG5317-T20A User’s Guide
93
Note: The GPON Device applies the security settings of the SSID1 profile (see Section
7.2 on page 83). If you want to use the WPS feature, make sure you have set the
security mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 32 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 17 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Select Enable to activate WPS on this GPON Device.
Add a new device with WPS Method
Method 1 Use this section to set up a WPS wireless network using Push Button Configuration (PBC).
Select Enable and click Apply to activate WPS method 1 on the GPON Device.
WPS Click this button to add another WPS-enabled wireless device (within wireless range of the
GPON Device) to your wireless network. This button may either be a physical button on the
outside of device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of pressing
this button.
Method 2 Use this section to set up a WPS wireless network by entering the PIN of the client into the
GPON Device. Select Enable and click Apply to activate WPS method 2 on the GPON
Device.
Register Enter the PIN of the device that you are setting up a WPS connection with and click
Register to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device’s
settings.
Note: You must also activate WPS on that device within two minutes to have it present its
PIN to the GPON Device.
To Next Page
Loading...
