Chapter 15 IP Drop-In
UAG CLI Reference Guide
113
The following example shows you how to set the drop-in WAN interface and LAN interface, set a
WAN host, turn on the dop-in mode and show the settings.
Router> configure terminal
Router(config)# ip drop-in
Router(drop-in)# wan-host 10.1.2.3
Router(drop-in)# wan-interface wan1 lan-interface lan1
Router(drop-in)# activate
Router(drop-in)# exit
Router(config)# show ip drop-in status
active : yes
wan_interface: wan1
lan_interface: lan1
Router(config)# show ip drop-in wan-host
Index WanHost
===============================================================================
1 10.1.2.3
Router(config)#
To Next Page
Loading...
