ZyXEL Communications UAG Series - Command Examples; Registration Status Commands (V4.00 and Later Only)

Chapter 5 Registration
UAG CLI Reference Guide
50
5.3.1 Command Examples
The following commands allow you to register your device with an existing account or create a new
account and register the device at one time, and activate a trial service subscription.
The following command displays the account information and whether the device is registered.
The following command displays the service registration status and type and how many days
remain before the service expires.
5.4 Registration Status Commands (V4.00 and Later Only)
The following table describes the commands available for registration status. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Router# configure terminal
Router(config)# device-register username alexctsui password 123456
Router(config)# service-register service-type trial service content-filter
Router# configure terminal
Router(config)# show device-register status
username : example
password : 123456
device register status : yes
expiration self check : no
Router# configure terminal
Router(config)# show service-register status all
Service Status Type Count Expiration
===========================================================================
Content-Filter Licensed Trial N/A 16
Table 10 Command Summary: Registration
COMMAND DESCRIPTION
show service-register status all Displays all service license information.
show service-register status extension-user Displays extension-user service license information.
It also displays the maximum number of wired and wireless users
that may connect to the UAG at the same time.
show service-register status external-ap-
control
Displays external-ap-control service license information.
It also displays how many managed APs the UAG can support with
your current license.
show service-register status sms Displays whether the SMS ticketing service is activated.