ZyXEL Communications UAG Series - Packet Flow Explore Commands Example

Chapter 63 Packet Flow Explore
UAG CLI Reference Guide
318
63.3 Packet Flow Explore Commands Example
The following example shows all routing related functions and their order.
The following example shows all SNAT related functions and their order.
The following example shows all activated policy routes.
The following example shows all activated 1-to-1 SNAT rules.
The following example shows all activated site-to-site VPN rules.
The following example shows all activated dynamic VPN rules.
The following example shows the default WAN trunk’s settings.
Router> show route order
route order: Direct Route, Policy Route, VPN 1-1 Mapping Route, 1-1 SNAT, SiteTo
Site VPN, Dynamic VPN, Static-Dynamic Route, Default WAN Trunk, Main Route
Router> show system snat order
snat order: Policy Route SNAT, VPN 1-1 Mapping SNAT, 1-1 SNAT, Loopback SNAT, De
fault SNAT
Router> show system route policy-route
No. PR NO. Source Destination Incoming DSCP Service Nexthop Type
Nexthop Info
===========================================================================
Router> show system route nat-1-1
No. VS Name Source Destination Outgoing Gateway
===========================================================================
Router> show system route site-to-site-vpn
No. Source Destination VPN Tunnel
===========================================================================
Router> show system route dynamic-vpn
No. Source Destination VPN Tunnel
===========================================================================
Router> show system route default-wan-trunk
No. Source Destination Trunk
===========================================================================
1 any any SYSTEM_DEFAULT_WAN_TRUNK