Chapter 57 System Remote Management
UAG CLI Reference Guide
288
This command displays FTP settings.
57.8 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your UAG supports SNMP agent functionality, which allows a manager
station to manage and monitor the UAG through the network. The UAG supports SNMP version one
(SNMPv1) and version two (SNMPv2c).
57.8.1 Supported MIBs
The UAG supports MIB II that is defined in RFC-1213 and RFC-1215. The UAG also supports private
MIBs (enterprise.mib and private.mib) to collect information about CPU and memory usage and
VPN total throughput. The focus of the MIBs is to let administrators collect statistical data and
monitor status and performance. You can download the UAG’s MIBs from www.zyxel.com.
57.8.2 SNMP Traps
The UAG will send traps to the SNMP manager when any one of the following events occurs:
Router# configure terminal
Router(config)# show ip ftp server status
active : yes
port : 21
certificate: default
TLS : no
service control:
No. Zone Address Action
========================================================================
Table 184 SNMP Traps
OBJECT LABEL OBJECT ID DESCRIPTION
Cold Start 1.3.6.1.6.3.1.1.5.1 This trap is sent when the UAG is turned on or an agent restarts.
linkDown 1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link is down.
linkUp 1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link is up.
authenticationFailure 1.3.6.1.6.3.1.1.5.5 This trap is sent when an SNMP request comes from non-
authenticated hosts.
To Next Page
Loading...
