ZyXEL Communications UAG Series - 7.4 Security Profile Commands

Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
64
It will also assign the SSID profile labeled ‘default’ in order to create WLAN VAP (wlan-1-1)
functionality within the radio profile.
7.3 AP Monitor Profile Commands
The monitor profile commands allow you to set up monitor mode configurations that allow your APs
to scan for other APs in the vicinity.
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for monitor profile management. You must
use the
configure terminal command to enter the configuration mode before you can use
these commands.
Router(config)# wlan-radio-profile RADIO01
Router(config-profile-radio)# activate
Router(config-profile-radio)# band 2.4G
Router(config-profile-radio)# 2g-channel 6
Router(config-profile-radio)# ch-width 20m
Router(config-profile-radio)# dtim-period 2
Router(config-profile-radio)# beacon-interval 100
Router(config-profile-radio)# ampdu
Router(config-profile-radio)# limit-ampdu 65535
Router(config-profile-radio)# subframe-ampdu 64
Router(config-profile-radio)# amsdu
Router(config-profile-radio)# limit-amsdu 4096
Router(config-profile-radio)# block-ack
Router(config-profile-radio)# guard-interval short
Router(config-profile-radio)# tx-mask 5
Router(config-profile-radio)# rx-mask 7
Router(config-profile-radio)# output-power 100%
Router(config-profile-radio)# ssid-profile 1 default
Table 16 Input Values for Monitor Profile Commands
LABEL DESCRIPTION
monitor_profile_name The monitor profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
wireless_channel_2g Sets the 2 GHz channel used by the profile. The channel range is 1 - 14.
Note: Your choice of channel may be restricted by regional regulations.
wireless_channel_5g Sets the 5 GHz channel used by the profile. The channel range is 36 - 165.
Note: Your choice of channel may be restricted by regional regulations.
Table 17 Command Summary: Monitor Profile
COMMAND DESCRIPTION
show wlan-monitor-profile {all |
monitor_profile_name}
Displays all monitor profiles or just the specified one.
wlan-monitor-profile rename
monitor_profile_name1
monitor_profile_name2
Gives an existing monitor profile (monitor_profile_name1) a
new name (monitor_profile_name2).