ZyXEL Communications UAG Series - ZON Commands; ZON Examples

Chapter 56 System
UAG CLI Reference Guide
280
56.8.2 ZON Commands
The following table describes the commands available for ZON. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
56.8.3 ZON Examples
This example enables LLDP discovery and displays whether LLDP discovery is enabled on the UAG.
Table 178 Command Summary: ZON
COMMAND DESCRIPTION
zon lldp server Activates LLDP discovery on the UAG.
This allows you to use Link Layer Discovery Protocol (LLDP) for
discovering and configuring LLDP-aware devices in the same
broadcast domain as the UAG that you are logged into using the
web configurator.
zon lldp server tx-hold <1..10> Sets the multipler used to calculate the TTL (Time To Live) value
for the transmitted LLDP packets. The TTL value determines how
long the device information can be saved on the neighbors.
LLDP TTL = the multipler * the LLDP transmission interval
zon lldp server tx-interval <1..600> Sets the interval (in seconds) at which the UAG sends a LLDP
packet to the neighbor.
zon zdp server Activates ZDP discovery on the UAG.
show zon lldp neighbors Displays the the UAG’s neighboring devices via LLDP.
show zon lldp server config Displays the LLDP settings.
show zon lldp server statistics Displays the LLDP traffic statistics.
show zon lldp server status Displays whether LLDP discovery is enabled.
show zon zdp server status Displays whether ZDP discovery is enabled.
Router(config)# zon lldp server
Router(config)# zon lldp server status
status: active
Router(config)#