ZyXEL Communications UAG Series - Email Daily Report Commands; Report Command Examples; Session Commands

Chapter 60 Reports and Reboot
UAG CLI Reference Guide
310
60.1.2 Report Command Examples
The following commands start collecting data, display the traffic reports, and stop collecting data.
60.1.3 Session Commands
This table lists the commands to display the current sessions for debugging or statistical analysis.
60.2 Email Daily Report Commands
The following table identifies the values used in some of these commands. Other input values are
discussed with the corresponding commands.
Router# configure terminal
Router(config)# show report lan1 ip
No. IP Address User Amount Direction
===================================================================
1 192.168.1.4 admin 1273(bytes) Outgoing
2 192.168.1.4 admin 711(bytes) Incoming
Router(config)# show report lan1 service
No. Proto Port Service Amount Direction
===============================================================================
1 tcp 80 www 5.920(MBytes) Outgoing
2 tcp 80 www 224.363(KBytes) Incoming
Router(config)# show report lan1 url
No. Hit URL
=====================================================================
1 1 140.114.79.60
Router(config)# show report status
Report status: on
Collect Statistics: since 2012-07-24 Tue 13:49:06 to 2012-07-24 Tue 14:12:46
Table 199 Session Commands
COMMAND DESCRIPTION
show conn [user
{username|any|unknown}] [service
{service-name|any|unknown}]
[source {ip|any}] [destination
{ip|any}] [begin <1..128000>]
[end <1..128000>]
Displays information about the selected sessions or about all sessions. You can
look at all the active sessions or filter the information by user name, service
object, source IP, destination IP, or session number(s).
any means all users, services and IP addresses respectively.
unknow means unknown users and services respectively.
show conn ip-traffic destination Displays information about traffic session sorted by the destination.
show conn ip-traffic source Displays information about traffic session sorted by the source.
show conn status Displays the number of active sessions.
Table 200 Input Values for Email Daily Report Commands
LABEL DESCRIPTION
e_mail An e-mail address. You can use up to 80 alphanumeric characters, underscores (_),
periods (.), or dashes (-), and you must use the @ character.