UAG CLI Reference Guide 326
CHAPTER 65
Watchdog Timer
This chapter provides information about the UAG’s watchdog timers.
65.1 Hardware Watchdog Timer
The hardware watchdog has the system restart if the hardware fails.
The hardware-watchdog-timer commands are for support engineers.
It is recommended that you not modify the hardware watchdog timer
settings.
65.2 Software Watchdog Timer
The software watchdog has the system restart if the core firmware fails.
The software-watchdog-timer commands are for support engineers.
It is recommended that you not modify the software watchdog timer
settings.
Table 208 hardware-watchdog-timer Commands
COMMAND DESCRIPTION
[no] hardware-watchdog-timer <4..37> Sets how long the system’s hardware can be unresponsive before resetting.
The no command turns the timer off.
show hardware-watchdog-timer status Displays the settings of the hardware watchdog timer.
Table 209 software-watchdog-timer Commands
COMMAND DESCRIPTION
[no] software-watchdog-timer
<10..600>
Sets how long the system’s core firmware can be unresponsive before
resetting. The no command turns the timer off.
show software-watchdog-timer status Displays the settings of the software watchdog timer.
show software-watchdog-timer log Displays a log of when the software watchdog timer took effect.
To Next Page
Loading...
