ZyXEL Communications UAG Series - Console Port Logging Commands

Chapter 59 Logs
UAG CLI Reference Guide
308
59.1.4.1 E-mail Profile Command Examples
The following commands set up e-mail log 1.
59.1.5 Console Port Logging Commands
This table lists the commands for the console port settings.
[no] logging mail <1..2> tls activate Sets the UAG to use Transport Layer Security (TLS) to have
encrypted communications between the mail server and the UAG.
The
no command disables TLS in communications between the
mail server and the UAG.
[no] logging mail <1..2> tls authenticate-
server
Sets the UAG to authenticate the mail server in the TLS
handshake.
The
no command sets the UAG to not authenticate the mail
server in the TLS handshake.
Table 196 logging Commands: E-mail Profile Settings (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# logging mail 1 address mail.zyxel.com.tw
Router(config)# logging mail 1 subject AAA
Router(config)# logging mail 1 authentication username lachang.li password XXXXXX
Router(config)# logging mail 1 send-log-to lachang.li@zyxel.com.tw
Router(config)# logging mail 1 send-alerts-to lachang.li@zyxel.com.tw
Router(config)# logging mail 1 from lachang.li@zyxel.com.tw
Router(config)# logging mail 1 schedule weekly day mon hour 3 minute 3
Router(config)# logging mail 1
Table 197 logging Commands: Console Port Settings
COMMAND DESCRIPTION
show logging status console Displays the current settings for the console log. (This log
is not discussed above.)
[no] logging console Enables the console log. The
no command disables the
console log.
logging console category module_name level {alert |
crit | debug | emerg | error | info | notice | warn}
Controls whether or not debugging information for the
specified priority is displayed in the console log, if logging
for this category is enabled.
[no] logging console category module_name Enables logging for the specified category in the console
log. The
no command disables logging.