ZyXEL Communications UAG Series - Drop-In Commands; Drop-In Limitations

Chapter 15 IP Drop-In
UAG CLI Reference Guide
112
15.1.1 Drop-In Limitations
• The interfaces in drop-in mode cannot join the port group of the interfaces that are not in drop-in
mode. But other interfaces can join a drop-in interface’s port group.
• The interfaces in drop-in mode cannot be part of a bridge interface.
• You must configure a drop-in WAN interface’s IP address before setting it to work in drop-in
mode.
• You cannot create a policy route, static route, NAT rule or VPN 1-1 mapping rule for an interface
in drop-in mode.
• You cannot enable IPnP, UPnP or Layer-2 isolation on a LAN interface in drop-in mode. The
interface cannot be used for printer management and web authentication nor provide SMS, free
time and billing services.
15.2 Drop-In Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
This table lists the ip drop-in commands. You must use the
configure terminal command to
enter the configuration mode before you can use these commands.
Table 57 Input Values for General Drop-In Commands
LABEL DESCRIPTION
interface_name The name of the Ethernet interface. This depends on the UAG model.
See Table 57 on page 112 for detailed information about the interface name.
Table 58 IP Drop-In Commands
COMMAND DESCRIPTION
no ip drop-in
activate
Disables the drop-in mode on the UAG.
ip drop-in Enters the ip drop-in sub-command mode to configure the drop-in settings.
activate Enables the drop-in mode on the UAG.
exit Leaves the sub-command mode.
[no] wan-host
ipv4_address
Sets the IPv4 address of the host that is connected to the UAG’s drop-in WAN interface and can be
accessed by the devices connected to the UAG’s drop-in LAN interface.
The no command removes the host IP address.
wan-interface
interface_name
lan-interface
interface_name
Sets the WAN interface and LAN interface of the UAG, which are to be in drop-in mode.
show ip drop-in
status
Displays whether drop-in mode is enabled on the UAG and the WAN and LAN interfaces that are
set to work in drop-in mode.
show ip drop-in wan-
host
Displays the IP address of the WAN host in drop-in mode.