ZyXEL Communications UAG Series - HTTP;HTTPS Command Examples; Requirements for Using SSH; Ssh; SSH Implementation on the UAG

Chapter 57 System Remote Management
UAG CLI Reference Guide
284
57.3.1 HTTP/HTTPS Command Examples
This following example adds a service control rule that allowed an administrator from the
computers with the IP addresses matching the Marketing address object to access the WAN zone
using HTTP service.
This command sets an authentication method used by the HTTP/HTTPS server to authenticate the
client(s).
This following example sets a certificate named MyCert used by the HTTPS server to authenticate
itself to the SSL client.
57.4 SSH
Unlike Telnet or FTP, which transmit data in clear text, SSH (Secure Shell) is a secure
communication protocol that combines authentication and data encryption to provide secure
encrypted communication between two hosts over an unsecured network.
57.4.1 SSH Implementation on the UAG
Your UAG supports SSH versions 1 and 2 using RSA authentication and four encryption methods
(AES, 3DES, Archfour, and Blowfish). The SSH server is implemented on the UAG for remote
management on port 22 (by default).
57.4.2 Requirements for Using SSH
You must install an SSH client program on a client computer (Windows or Linux operating system)
that is used to connect to the UAG over SSH.
Router# configure terminal
Router(config)# ip http server table admin rule append access-group Marketing zone WAN
action accept
Router# configure terminal
Router(config)# ip http authentication Example
Router# configure terminal
Router(config)# ip http secure-server cert MyCert