ZyXEL Communications UAG Series - Chapter 7 Wireless LAN Profiles; AP Radio Profile Commands; Wireless LAN Profiles Overview

UAG CLI Reference Guide 59
CHAPTER 7
Wireless LAN Profiles
This chapter shows you how to configure wireless LAN profiles on your UAG.
7.1 Wireless LAN Profiles Overview
The managed Access Points designed to work explicitly with your UAG do not have on-board
configuration files, you must create “profiles” to manage them. Profiles are preset configurations
that are uploaded to the APs and which manage them. They include: Radio and Monitor profiles,
SSID profiles, Security profiles, and MAC Filter profiles. Altogether, these profiles give you absolute
control over your wireless network.
7.2 AP Radio Profile Commands
The radio profile commands allow you to set up configurations for the radios onboard your various
APs.
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 14 Input Values for General Radio Profile Commands
LABEL DESCRIPTION
radio_profile_name The radio profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
wlan_role Sets the wireless LAN radio operating mode. At the time of writing, you can use
ap for Access Point.
wireless_channel_2g Sets the 2 GHz channel used by this radio profile. The channel range is 1 - 14.
Note: Your choice of channel may be restricted by regional regulations.
wireless_channel_5g Sets the 5 GHz channel used by this radio profile. The channel range is 36 -
165.
Note: Your choice of channel may be restricted by regional regulations.
wlan_hctw Sets the HT channel width. Select either auto or 20m.
wlan_htgi Sets the HT guard interval. Select either long or short.
wlan_2g_basic_speed Sets the basic band rate for 2.4 GHz. The available band rates are 1.0, 2.0,
5.5, 11.0, 6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0.
wlan_2g_support_speed Sets the support rate for the 2.4 GHz band. The available band rates are: 1.0,
2.0, 5.5, 11.0, 6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0.