ZyXEL Communications UAG Series - Address Group Commands; Address Object Commands

Chapter 46 Addresses
UAG CLI Reference Guide
236
46.2.1 Address Object Commands
This table lists the commands for address objects.
46.2.1.1 Address Object Command Examples
The following example creates three IPv4 address objects and then deletes one.
46.2.2 Address Group Commands
This table lists the commands for address groups.
Table 148 address-object and address6-object Commands
COMMAND DESCRIPTION
show {address-object | address6-object |
service-object | schedule-object}
[object_name]
Displays information about the specified object or all the objects of
the specified type.
address-object object_name {ip | ip_range |
ip_subnet | interface-ip | interface-subnet |
interface-gateway} {interface}
Creates the specified IPv4 address object using the specified
parameters.
ip_range: <1..255>.<0..255>.<0..255>.<1..255>-
<1..255>.<0..255>.<0..255>.<1..255>
ip_subnet: <1..255>.<0..255>.<0..255>.<0..255>/<1..32>
interface: Specify an interface when you create an object based
on an interface.
no address-object object_name Deletes the specified address object.
address-object rename object_name object_name Renames the specified address (first object_name) to the second
object_name.
Router# configure terminal
Router(config)# address-object A0 192.168.1.1
Router(config)# address-object A1 192.168.1.1-192.168.1.20
Router(config)# address-object A2 192.168.1.0/24
Router(config)# show address-object
Object name Type Address Ref.
=====================================================================
A0 HOST 192.168.1.1 0
A1 RANGE 192.168.1.1-192.168.1.20 0
A2 SUBNET 192.168.1.0/24 0
Router(config)# no address-object A2
Router(config)# show address-object
Object name Type Address Ref.
=====================================================================
A0 HOST 192.168.1.1 0
A1 RANGE 192.168.1.1-192.168.1.20 0
Table 149 object-group Commands: Address Groups
COMMAND DESCRIPTION
show object-group {address | address6}
[group_name]
Displays information about the specified address group or about all
address groups.
[no] object-group address group_name Creates the specified address group if necessary and enters sub-
command mode. The no command deletes the specified address group.