ZyXEL Communications UAG Series - Ipnp Commands Example

Chapter 28 IPnP
UAG CLI Reference Guide
157
28.3 IPnP Commands Example
The following example enables IPnP on the UAG and interface lan1. It also displays the IPnP
settings.
Router# configure terminal
Router(config)# ip ipnp activate
Router(config)# ip ipnp config
Router(ipnp)# interface lan1
Router(ipnp)# exit
Router(config)# show ip ipnp activation
IPnP Status: yes
Router(config)# show ip ipnp interface
interface
===============================================================================
lan1
Router(config)#