Chapter 39 Bandwidth Management
UAG CLI Reference Guide
191
39.2.1 Bandwidth Sub-Commands
The following table describes the sub-commands for several bwm commands.
bwm move <1..127> to <1..127> Moves a policy to the number that you specified.
show bwm activation Displays whether bandwidth management is enabled.
show bwm all Displays all bandwidth management policies.
show bwm default Displays the default bandwidth management policy.
Table 118 bwm Commands (continued)
COMMAND DESCRIPTION
Table 119 bwm Sub-commands
COMMAND DESCRIPTION
[no] activate Enables a policy. The no command disables the policy.
[no] description description Sets a descriptive name (up to 60 printable ASCII
characters) for a policy.
The no command removes the descriptive name from the
policy.
[no] destination address_object Sets the destination IP address or address group for whom
this policy applies.
The no command resets the destination IP address(es) to
the default (any). any
means all IP addresses.
[no] dscp {<0..63> | any | class {af11 | af12 |
af13 | af21 | af22 | af23 | af31 | af32 | af33 |
af41 | af42 | af43 | cs0 | cs1 | cs2 | cs3 | cs4
| cs5 | cs6 | cs7 | default | wmm_be0 | wmm_be24
| wmm_bk16 | wmm_bk8 | wmm_vi32 | wmm_vi40 |
wmm_vo48 | wmm_vo56}}
Specifies a DSCP code point value or sets an AF class or
QoS access class of incoming or outgoing packets to which
this policy applies.
any means all DSCP value or no DSCP marker.
The no command resets the DSCP code to the default
(any).
[no] inbound ceiling {<0..1048576> | maximize-
bandwidth-usage}
Sets the maximum bandwidth allowed for incoming traffic
or enables maximize bandwidth usage to let the traffic
matching this policy “borrow” any unused bandwidth on the
incoming interface.
The no command resets the inbound maximum bandwidth
to the default (0).
[no] inbound guarantee-bandwidth <0..1048576>
priority <1..7>
Sets how much inbound bandwidth, in kilobits per second,
this policy allows the traffic to use and also sets a number
between 1 and 7 to set the priority for traffic that matches
this policy. The smaller the number, the higher the priority.
Inbound refers to the traffic the UAG sends to a
connection’s initiator.
The no command resets the inbound guarantee bandwidth
to the default (0).
[no] inbound-dscp-mark {<0..63> | class {af11 |
af12 | af13 | af21 | af22 | af23 | af31 | af32 |
af33 | af41 | af42 | af43 | cs0 | cs1 | cs2 |
cs3 | cs4 | cs5 | cs6 | cs7 | default | wmm_be0
| wmm_be24 | wmm_bk16 | wmm_bk8 | wmm_vi32 |
wmm_vi40 | wmm_vo48 | wmm_vo56}}
Sets the DSCP value to apply to the incoming packets that
match this policy.
default: to have the UAG set the DSCP value of the
packets to 0.
The no command resets the incoming DSCP code to the
default (preserve) and have the UAG keep the packets’
original DSCP value.
To Next Page
Loading...
