ZyXEL Communications UAG Series - 50.10 Restoring the Firmware

Chapter 55 Dynamic Guest Accounts
UAG CLI Reference Guide
270
55.2.1 dynamic-guest Sub-commands
The following table describes the sub-commands for several dynamic-guest commands. Note that
not all rule commands use all the sub-commands listed here.
[no] dynamic-guest user_name Creates a dynamic guest account (billing-user) with the specified user
name and enters the dynamic-guest sub-command mode to set the
password and timeout settings. See Table 170 on page 270 for the sub-
commands.
The no command removes the specified dynamic-guest account.
show dynamic-guest log Displays all the dynamic guest accounts which are either active or expired.
show dynamic-guest log create-time
begin yyyy-mm-dd hh:mm end yyyy-mm-dd
hh:mm
Displays all the active and/or expired dynamic guest accounts that were
generated within a specified period of time.
show dynamic-guest users Displays all the active dynamic guest accounts on the UAG.
Table 169 dynamic-guest Commands (continued)
COMMAND DESCRIPTION
Table 170 dynamic-guest Sub-commands
COMMAND DESCRIPTION
bandwidth {upload | download}
<0..1048576> priority <1..7>
Specifies the maximum bandwidth allowed for the user account in kilobits
per second and types a number between 1 and 7 to set the priority for the
user’s traffic. The smaller the number, the higher the priority.
upload refers to the traffic the UAG sends out from a user.
download refers to the traffic the UAG sends to a user.
[no] bandwidth activate Turns on bandwidth management for the user account.
The no command disables bandwidth management for the user account.
charge price Sets the account’s price, up to 99999999.99, per time unit.
create-time yyyy-mm-dd hh:mm Sets the date and time the account is created.
expire-time yyyy-mm-dd hh:mm Sets the date and time the account becomes invalid.
password password Sets the password for the account.
payment-info {cash | payment-
service}
Sets the method of payment for the account.
phone phone_number Sets the mobile phone number for the account.
quota {total | upload | download}
megabytes <0..1023>
Sets how much downstream and/or upstream data in Megabytes can be
transmitted through the external interface before the account expires. 0
means there is no data limit for the user account.
quota {total | upload | download}
gigabytes <0..100>
Sets how much downstream and/or upstream data in Gigabytes can be
transmitted through the external interface before the account expires. 0
means there is no data limit for the user account.
quota type {total | upload-
download}
Sets a limit for the user account. This only applies to user’s traffic that is
received or transmitted through the external interface.
Note: When the limit is exceeded, the user is not allowed to access the
Internet through the UAG.
total: set a limit on the total traffic in both directions.
upload-download: set a limit on the upstream traffic and downstream
traffic respectively.