Chapter 56 System
UAG CLI Reference Guide
279
56.7.2 Authentication Server Command Examples
The following example shows you how to enable the authentication server feature on the UAG and
sets a trusted RADIUS client profile. This example also shows you the authentication server and
client profile settings.
56.8 ZON Overview
The ZyXEL One Network (ZON) utility uses the ZyXEL Discovery Protocol (ZDP) for discovering and
configuring ZDP-aware ZyXEL devices in the same broadcast domain as the computer on which
ZON is installed.
The ZON Utility issues requests via ZDP and in response to the query, the ZyXEL device responds
with basic information including IP address, firmware version, location, system and model name.
The information is then displayed in the ZON Utility screen and you can perform tasks like basic
configuration of the devices and batch firmware upgrade in it. You can download the ZON Utility at
www.zyxel.com and install it on a computer.
56.8.1 LLDP
LLDP is a layer-2 protocol that allows a network device to advertise its identity and capabilities on
the local network. It also allows the device to maintain and store information from adjacent devices
which are directly connected to the network device. This helps you discover network changes and
perform necessary network reconfiguration and management.
Router# configure terminal
Router(config)# auth-server activate
Router(config)# auth-server trusted-client AP-1
Router(config-trusted-client-AP-1)# activate
Router(config-trusted-client-AP-1)# ip address 10.10.1.2 255.255.255.0
Router(config-trusted-client-AP-1)# secret 12345678
Router(config-trusted-client-AP-1)# exit
Router(config)# show auth-server status
activation: yes
authentication method: default
certificate: default
Router(config)# show auth-server trusted-client AP-1
Client: AP-1
Activation: yes
Description:
IP: 10.10.1.2
Netmask: 255.255.255.0
Secret: VQEq907jWB8=
Router(config)#
To Next Page
Loading...
