ZyXEL Communications UAG Series - Telnet; Telnet Commands; Telnet Commands Examples

Chapter 57 System Remote Management
UAG CLI Reference Guide
286
57.5 Telnet
You can configure your UAG for remote Telnet access.
57.6 Telnet Commands
The following table describes the commands available for Telnet. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
57.6.1 Telnet Commands Examples
This command sets a service control rule that allowed the computers with the IP addresses
matching the specified address object to access the specified zone using Telnet service.
This command displays Telnet settings.
Table 182 Command Summary: Telnet
COMMAND DESCRIPTION
[no] ip telnet server Allows Telnet access to the UAG CLI. The no command disables Telnet access
to the UAG CLI.
[no] ip telnet server port <1..65535> Sets the Telnet service port number. The
no command resets the Telnet
service port number back to the factory default (23).
ip telnet server rule
{rule_number|append|insert
rule_number} access-group
{ALL|address_object} zone
{ALL|zone_object} action
{accept|deny}
Sets a service control rule for Telnet service.
address_object: The name of the IP address (group) object. You may use 1-
31 alphanumeric characters, underscores(
_), or dashes (-), but the first
character cannot be a number. This value is case-sensitive.
zone_object: The name of the zone. Use up to 31 characters (a-zA-Z0-9_-).
The name cannot start with a number. This value is case-sensitive.
The UAG uses pre-defined zone names like DMZ, LAN1, LAN2, SSL VPN, IPSec
VPN, and WAN.
ip telnet server rule move
rule_number to rule_number
Changes the index number of a service control rule.
no ip telnet server rule rule_number Deletes a service control rule for Telnet service.
show ip telnet server status Displays Telnet settings.
Router# configure terminal
Router(config)# ip telnet server rule 11 access-group RD zone LAN action
-> accept
Router# configure terminal
Router(config)# show ip telnet server status
active : yes
port : 23
service control:
No. Zone Address Action
========================================================================
Router(config)#