ZyXEL Communications UAG Series - Application Object Commands; Application Object Commands Summary; Chapter 45 Application Object

UAG CLI Reference Guide 232
CHAPTER 45
Application Object
Check that you have the latest App Patrol signatures.
45.1 Application Object Commands Summary
The following table describes the values required for many application object commands. Other
values are discussed with the corresponding commands.
45.1.1 Application Object Commands
This table lists the application object commands.
Table 144 Input Values for Application Object Commands
LABEL DESCRIPTION
object_name Type the name of the object.
description This is a description of the object
sid This is the associated
IDP and App Patrol signature ID number.
Table 145 application-object Commands
COMMAND DESCRIPTION
show application-object object_name Displays information on the named application object.
application-object object_name Creates an object with the specified name. You may use 1-31
alphanumeric characters, underscores(
_), or dashes (-), but the first
character cannot be a number. This value is case-sensitive. The no
command disables it.
[no] description description Write a description of the object.
[no] application sid Write a valid signature ID for the object. The no command disables it.
no application-object object_name Deletes the object with the specified name.
application-object rename object_name1
object_name2
Renames the specified object with a new name.