ZyXEL Communications UAG Series - Page 311

Chapter 60 Reports and Reboot
UAG CLI Reference Guide
311
Use these commands to have the UAG e-mail you system statistics every day. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 201 Email Daily Report Commands
COMMAND DESCRIPTION
show daily-report status Displays the e-mail daily report settings.
daily-report Enters the sub-command mode for configuring daily e-mail
reports settings.
[no] activate Turns daily e-mail reports on or off.
draw-usage-graphics Has the report e-mail include usage graphs.
smtp-address {ip | hostname} Sets the SMTP mail server IP address or domain name.
[no] smtp-auth activate Enables or disables SMTP authentication.
smtp-auth username username password password Sets the username and password for SMTP authentication.
no smtp-address Resets the SMTP mail server configuration.
no smtp-auth username Resets the authentication configuration.
[no] smtp-port <1..65535> Sets the SMTP authentication port. The no command deletes
the setting.
mail-subject set subject Configures the subject of the report e-mails. Spaces are
allowed.
no mail-subject set Clears the configured subject for the report e-mails.
[no] mail-subject append system-name Determines whether the system name will be appended to the
subject of the report e-mails.
[no] mail-subject append date-time Determines whether the sending date-time will be appended
at subject of the report e-mails.
[no] mail-from e_mail Sets the sender e-mail address of the report e-mails.
[no] mail-to-1 e_mail Sets to whom the UAG sends the report e-mails (up to five
recipients).
[no] mail-to-2 e_mail See above.
[no] mail-to-3 e_mail See above.
[no] mail-to-4 e_mail See above.
[no] mail-to-5 e_mail See above.
[no] item cf-report Determines whether or not content filtering statistics are
included in the report e-mails.
[no] item cpu-usage Determines whether or not CPU usage statistics are included
in the report e-mails.
[no] item mem-usage Determines whether or not memory usage statistics are
included in the report e-mails.
[no] item port-usage Determines whether or not port usage statistics are included
in the report e-mails.
[no] item session-usage Determines whether or not session usage statistics are
included in the report e-mails.
[no] item traffic-report Determines whether or not network traffic statistics are
included in the report e-mails.
schedule hour <0..23> minute <00..59> Sets the time for sending out the report e-mails.
[no] reset-counter Determines whether or not to discard all report data and
starts all of the report statistics data counters over at zero
after successfully sending out a report e-mail.