Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
62
[no] amsdu Activates MPDU frame aggregation for this profile. Use the no
parameter to disable it.
Mac Service Data Unit (MSDU) aggregation collects Ethernet
frames without any of their 802.11n headers and wraps the
header-less payload in a single 802.11n MAC header. This method
is useful for increasing bandwidth throughput. It is also more
efficient than A-MPDU except in environments that are prone to
high error rates.
By default this is enabled.
limit-amsdu <2290..4096> Sets the maximum frame size to be aggregated.
The default is 4096.
[no] multicast-to-unicast “Multicast to unicast” broadcasts wireless multicast traffic to all
wireless clients as unicast traffic to provide more reliable
transmission. The data rate changes dynamically based on the
application’s bandwidth requirements. Although unicast provides
more reliable transmission of the multicast traffic, it also
produces duplicate packets.
The no command turns multicast to unicast off to send wireless
multicast traffic at the rate you specify with the 2g-multicast-
speed or 5g-multicast-speed command.
[no] block-ack Makes block-ack active or inactive. Use the no parameter to
disable it.
ch-width wlan_htcw Sets the channel width for this profile.
guard-interval wlan_htgi Sets the guard interval for this profile.
The default for this is short.
2g-basic-speed wlan_2g_basic_speed Sets the 2.4 GHz basic band rates.
The default is 1.0 2.0 5.5 11.0.
2g-channel wireless_channel_2g Sets the broadcast band for this profile in the 2.4 GHz frequency
range. The default is 6.
2g-mcs-speed {disable | wlan_mcs_speed} Disables or sets the 2.4 GHz HT MCS rate.
The default is 0~15.
2g-multicast-speed wlan_2g_support_speed When you disable multicast to unicast, use this command to set
the data rate { 1.0 | 2.0 | … } in Mbps for 2.4 GHz multicast
traffic.
2g-support-speed {disable |
wlan_2g_support_speed}
Disables or sets the 2.4 GHz support rate.
The default is 1.0~54.0.
5g-basic-speed wlan_5g_basic_speed Sets the 5 GHz basic band rate.
The default is 6.0 12.0 24.0.
5g-channel wireless_channel_5g Sets the broadcast band for this profile in the 5 GHz frequency
range. The default is 36.
5g-mcs-speed {disable | wlan_mcs_speed} Disables or sets the 5 GHz HT MCS rate.
The default is 0~15.
5g-multicast-speed {
wlan_5g_basic_speed} When you disable multicast to unicast, use this command to set
the data rate { 6.0 | 9.0 | … } in Mbps for 5 GHz multicast
traffic.
Table 15 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
