Chapter 1 Command Line Interface
ZyWALL (ZLD) CLI Reference Guide
12
" The ZyWALL might force you to log out of your session if reauthentication
time, lease time, or idle timeout is reached. See Chapter 24 on page 211 for
more information about these settings.
1.2.1 Console Port
The default settings for the console port are as follows.
When you turn on your ZyWALL, it performs several internal tests as well as line
initialization. You can view the initialization information using the console port.
• Garbled text displays if your terminal emulation program’s speed is set lower than the
ZyWALL’s.
• No text displays if the speed is set higher than the ZyWALL’s.
• If changing your terminal emulation program’s speed does not get anything to display,
restart the ZyWALL.
• If restarting the ZyWALL does not get anything to display, contact your local customer
support.
Figure 1 Console Port Power-on Display
After the initialization, the login screen displays.
Figure 2 Login Screen
Table 1 Managing the ZyWALL: Console Port
SETTING VALUE
Speed 115200 bps
Data Bits 8
Parity None
Stop Bit 1
Flow Control Off
FLASH: AMD 16M
BootModule Version: V1.08 | 12/04/2007 15:36:17
DRAM: Size = 256 Mbytes
DRAM POST: Testing: 262144K
Welcome to ZyWALL 1050
Username:
To Next Page
Loading...
