ZyXEL Communications ZYWALL USG CLI - 9.2 Zone Commands Summary

Chapter 9 Zones
ZyWALL (ZLD) CLI Reference Guide
92
9.2 Zone Commands Summary
The following table describes the values required for many zone commands. Other values are
discussed with the corresponding commands.s
This table lists the zone commands.
Table 48 Input Values for Zone Commands
LABEL DESCRIPTION
profile_name The name of a zone, or the name of a VPN tunnel.
For the ZyWALL USG 300 and above, use up to 31 characters (a-zA-Z0-9_-). The
name cannot start with a number. This value is case-sensitive.
The ZyWALL USG 100 and 200 models use pre-defined zone names like DMZ,
LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and WAN.
Table 49 zone Commands
COMMAND DESCRIPTION
show zone [profile_name] Displays information about the specified zone or
about all zones.
[no] zone profile_name Creates the zone if necessary and enters sub-
command mode. The
no command deletes the
zone.
zone profile_name
[no] block Blocks intra-zone traffic. The
no command allows
intra-zone traffic.
[no] interface interface_name Adds the specified interface to the specified zone.
The no command removes the specified interface
from the specified zone. See Section 5.2 on page
49 for information about interface names.
[no] crypto profile_name Adds the specified IPSec VPN tunnel to the
specified zone. The
no command removes the
specified IPSec VPN tunnel from the specified
zone.
[no] sslvpn profile_name Adds the specified SSL VPN tunnel to the specified
zone. The
no command removes the specified
SSL VPN tunnel from the specified zone.