Chapter 34 System Remote Management
ZyWALL (ZLD) CLI Reference Guide
268
34.10.4.1 Dial-in Management Command Examples
The following commands show you how to set up dial-in management with the following
parameters: active, port speed 57600, initial-string ATDT, and description “I am dial-in
management”.
34.11 Vantage CNM
Vantage CNM (Centralized Network Management) is a browser-based global management
solution that allows an administrator from any location to easily configure, manage, monitor
and troubleshoot ZyXEL devices located worldwide. See the Vantage CNM User's Guide for
details.
If you allow your ZyWALL to be managed by the Vantage CNM server, then you should not
do any configurations directly to the ZyWALL (using either the web configurator or
commands) without notifying the Vantage CNM administrator.
[no] description description Specifies the description for the dial-in management
connection. The
no command clears the description.
description: You can use alphanumeric and
()+/
:=?!*#@$_%- characters, and it can be up to 60
characters long.
[no] initial-string initial_string Specifies the initial string of the auxiliary interface. The
no command removes the initial string.
initial_string: You can use up to 64 characters.
Semicolons (;) and backslashes (\) are not allowed.
[no] mute Stops the external serial modem from making audible
sounds during a dial-in management session. The
no
command turns the sounds back on.
[no] port-speed {9600 | 19200 | 38400 |
57600 | 115200}
Specifies the baud rate of the auxiliary interface. The
no
command sets the baud rate to 115200.
show dial-in Displays dial-in management settings.
Table 159 Command Summary: Dial-in Management
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# dial-in
Router(config-dial-in)# activate
Router(config-dial-in)# port-speed 57600
Router(config-dial-in)# initial-string ATDT
Router(config-dial-in)# description I am dial-in management
Router(config-dial-in)# exit
To Next Page
Loading...
