ZyXEL Communications ZYWALL USG CLI - 18.2 Application Patrol Commands Summary; 18.2.1 Pre-defined Application Commands

Chapter 18 Application Patrol
ZyWALL (ZLD) CLI Reference Guide
144
18.2 Application Patrol Commands Summary
The following table describes the values required for many application patrol commands.
Other values are discussed with the corresponding commands.
The following sections list the application patrol commands.
18.2.1 Pre-defined Application Commands
This table lists the commands for each pre-defined application.
Table 72 Input Values for Application Patrol Commands
LABEL DESCRIPTION
protocol_name The name of a pre-defined application. These are listed by category.
general:
ftp | smtp | pop3 | irc | http
im: msn | aol-icq | yahoo | qq
p2p: bittorrent | eDonkey | fasttrack | gnutella | napster |
h323 | sip | soulseek
stream: rtsp
rule_number The number of an application patrol rule. 1 - X where X is the highest number of
rules the ZyWALL model supports. See the ZyWALL’s User’s Guide for details.
zone_name The name of a zone. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
schedule_name The name of a schedule. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
Table 73 app Commands: Pre-Defined Applications
COMMAND DESCRIPTION
app protocol_name {forward | drop | reject} Specifies what action the ZyWALL should take
when it identifies this application.
[no] app protocol_name activate Enables application patrol for the specified
application. The
no command disables application
patrol for the specified application.
app protocol_name mode {portless | portbase} Specifies how the ZyWALL identifies this
application.
[no] app protocol_name log [alert] Creates log entries (and alerts) for the specified
application. The
no command does not create any
log entries.
[no] app protocol_name bwm Turns on bandwidth management for the specified
application. The no command turns off bandwidth
management for the specified application.
app protocol_name bandwidth <0..102400> Specifies the bandwidth limit (in kilobits per
second) for the specified application.