ZyWALL (ZLD) CLI Reference Guide
311
CHAPTER 41
Watchdog Timer
This chapter provides information about the ZyWALL’s watchdog timers.
41.1 Hardware Watchdog Timer
The hardware watchdog has the system restart if the hardware fails.
1 The hardware-watchdog-timer commands are for support engineers. It
is recommended that you not modify the hardware watchdog timer settings.
41.2 Software Watchdog Timer
The software watchdog has the system restart if the core firmware fails.
1 The software-watchdog-timer commands are for support engineers. It
is recommended that you not modify the software watchdog timer settings.
Table 182 hardware-watchdog-timer Commands
COMMAND DESCRIPTION
[no] hardware-watchdog-timer <4..37> Sets how long the system’s hardware can be
unresponsive before resetting. The no command
turns the timer off.
show hardware-watchdog-timer status Displays the settings of the hardware watchdog
timer.
Table 183 software-watchdog-timer Commands
COMMAND DESCRIPTION
[no] software-watchdog-timer <10..600> Sets how long the system’s core firmware can be
unresponsive before resetting. The no command
turns the timer off.
To Next Page
Loading...
