Chapter 37 Reports and Reboot
ZyWALL (ZLD) CLI Reference Guide
298
37.1.2 Report Command Examples
The following commands start collecting data, display the traffic reports, and stop collecting
data.
37.1.3 Session Commands
This table lists the command to display the current sessions.
37.2 Email Daily Report Commands
The following table identifies the values used in some of these commands. Other input values
are discussed with the corresponding commands.
Router# configure terminal
Router(config)# show report ge1 ip
No. IP Address User Amount Direction
===================================================================
1 192.168.1.4 admin 1273(bytes) Outgoing
2 192.168.1.4 admin 711(bytes) Incoming
Router(config)# show report ge1 service
No. Port Service Amount Direction
====================================================================
1 21 ftp 1273(bytes) Outgoing
2 21 ftp 711(bytes) Incoming
Router(config)# show report ge1 url
No. Hit URL
=====================================================================
1 1 140.114.79.60
Router(config)# show report status
Report status: on
Collection period: 0 days 0 hours 0 minutes 18 seconds
Table 175 session Commands
COMMAND DESCRIPTION
show conn [user username] [service service-
name] [source ip] [destination ip] [begin
<1..128000>] [end <1..128000>]
Displays information about the selected sessions
or about all sessions. You can select sessions by
user name, service object, source IP, destination
IP, or session number(s).
show conn ip-traffic destination Displays information about traffic session sorted by
the destination.
show conn ip-traffic source Displays information about traffic session sorted by
the source.
show conn status Displays the number of active sessions.
Table 176 Input Values for Email Daily Report Commands
LABEL DESCRIPTION
e_mail An e-mail address. You can use up to 80 alphanumeric characters, underscores
(_), periods (.), or dashes (-), and you must use the @ character.
To Next Page
Loading...
