Chapter 1 Command Line Interface
ZyWALL (ZLD) CLI Reference Guide
20
1.6.3 Entering Partial Commands
The CLI does not accept partial or incomplete commands. You may enter a unique part of a
command and press
[TAB] to have the ZyWALL automatically display the full command.
For example, if you enter
config and press [TAB] , the full command of configure
automatically displays.
If you enter a partial command that is not unique and press
[TAB], the ZyWALL displays a list
of commands that start with the partial command.
Figure 13 Non-Unique Partial Command Example
1.6.4 Entering a ? in a Command
Typing a ? (question mark) usually displays help information. However, some commands
allow you to input a ?, for example as part of a string. Press [CTRL+V] on your keyboard to
enter a ? without the ZyWALL treating it as a help query.
1.6.5 Command History
The ZyWALL keeps a list of commands you have entered for the current CLI session. You can
use any commands in the history again by pressing the up (y) or down (z) arrow key to scroll
through the previously used commands and press
[ENTER].
1.6.6 Navigation
Press [CTRL]+A to move the cursor to the beginning of the line. Press [CTRL]+E to move the
cursor to the end of the line.
1.6.7 Erase Current Command
Press [CTRL]+U to erase whatever you have currently typed at the prompt (before pressing
[ENTER]).
Router# c [TAB]
clear configure copy
Router# co [TAB]
configure copy
To Next Page
Loading...
