Chapter 6 Trunks
ZyWALL (ZLD) CLI Reference Guide
79
6.7 Link Sticking Commands Summary
The following table lists the ip load-balancing link-sticking commands for
link sticking. (The link sticking commands have the prefix ip load-balancing because
they affect the ZyWALL’s load balancing behavior.) You must use the
configure
terminal
command to enter the configuration mode before you can use these commands.
See Table 35 on page 76 for details about the values you can input with these commands.
6.8 Link Sticking Command Example
This example shows how to activate link sticking and set the timeout to 600 seconds (ten
minutes).
Table 37 ip load-balancing link-sticking Commands Summary
COMMAND DESCRIPTION
[no] ip load-balancing link-
sticking activate
Turns link sticking on or off.
[no] ip load-balancing link-
sticking timeout timeout
Sets for how many seconds (30-3600) the ZyWALL
sends all of each local computer’s traffic through one
WAN interface.
show ip load-balancing link-
sticking status
Displays the current link sticking settings.
Router(config)# ip load-balancing link-sticking activate
Router(config)# ip load-balancing link-sticking timeout 600
Router(config)# show ip load-balancing link-sticking status
active : yes
timeout : 300
To Next Page
Loading...
