ZyXEL Communications ZYWALL USG CLI - Debug Commands

Chapter 2 User and Privilege Modes
ZyWALL (ZLD) CLI Reference Guide
29
2.1.1 Debug Commands
Debug commands marked with an asterisk (*) are not available when the debug flag is on and
are for service personnel use only. The debug commands follow a syntax that is Linux-based,
so if there is a Linux equivalent, it is displayed in this chapter for your reference.
Table 5 Debug Commands
COMMAND SYNTAX DESCRIPTION LINUX COMMAND EQUIVALENT
debug alg ALG debug commands
debug app Application patrol debug command
debug app show l7protocol
(*)
Shows app patrol protocol list > cat /etc/l7_protocols/
protocol.list
debug ca (*) Certificate debug commands
debug cmdexec {on|off} ZyShell debug commands
debug core-file (*) Display/Flush/Move system core files
debug device-ha (*) Device HA debug commands
debug force-auth (*) Force authentication debug commands
debug gui (*) GUI cgi related debug commands
debug gui show cgidump (*) Shows gui cgi command buffer > cat /tmp/zysh-cgi.dump
debug hardware (*) Hardware debug commands
debug idp IDP debug command
debug interface ifconfig
[interface]
Shows system interfaces detail > ifconfig [interface]
debug kernel (*) Kernel debug commands
debug myzyxel server (*) Myzyxel.com debug commands
debug network arpignore (*) Enable/Display the ignoring of ARP
responses for interfaces which don't
own the IP address
cat /proc/sys/net/ipv4/
conf/*/arp_ignore
debug no myzyxel server (*) Set the myZyXEL.com registration/
update server to the official site
debug policy-route (*) Policy route debug command
debug service-register Service registration debug command
debug content-filter zsb
server {ip | domain_name}
Safe browsing debug command
debug show content-filter
server
Category-based content filtering debug
command
debug show myzyxel server
status
Myzyxel.com debug commands
debug show ipset Lists the ZyWALL ‘s received cards.
debug show myzyxel server
status
Myzyxel.com debug commands
debug system dmesg Shows kernel debug messages > demsg
debug system free Shows free and used memory in the
system
> free
debug system ip addr Shows interface IP address information > ip addr