ZyWALL (ZLD) CLI Reference Guide
291
CHAPTER 36
Logs
This chapter provides information about the ZyWALL’s logs.
" When the system log reaches the maximum number of log messages, new log
messages automatically overwrite existing log messages, starting with the
oldest existing log message first.
See the User’s Guide for the maximum number of system log messages in the ZyWALL.
36.1 Log Commands Summary
The following table describes the values required for many log commands. Other values are
discussed with the corresponding commands.
The following sections list the logging commands.
36.1.1 Log Entries Commands
This table lists the commands to look at log entries.
Table 166 Input Values for Log Commands
LABEL DESCRIPTION
module_name The name of the category;
kernel, syslog, .... The default category
includes debugging messages generated by open source software. The
all
category includes all messages in all categories.
Table 167 logging Commands: Log Entries
COMMAND DESCRIPTION
show logging entries [priority pri] [category
module_name] [srcip ip] [dstip ip] [service
service_name] [begin <1..512> end <1..512>]
[keyword keyword]
Displays the selected entries in the system log.
PRI: alert | crit | debug | emerg | error | info | notice
| warn
keyword: You can use alphanumeric and
()+/
:=?!*#@$_%- characters, and it can be up to 63
characters long.This searches the message,
source, destination, and notes fields.
show logging entries field field [begin
<1..512> end <1..512>]
Displays the selected fields in the system log.
field: time | msg | src | dst | note | pri | cat | all
To Next Page
Loading...
