ZyWALL (ZLD) CLI Reference Guide
161
CHAPTER 20
IDP Commands
This chapter introduces IDP-related commands.
20.1 Overview
Commands mostly mirror web configurator features. It is recommended you use the web
configurator for IDP features such as searching for web signatures, creating/editing an IDP
profile or creating/editing a custom signature. Some web configurator terms may differ from
the command-line equivalent.
" The “no” command negates the action or returns it to the default value.
The following table lists valid input for IDP commands.
20.2 General IDP Commands
20.2.1 IDP Activation
" You must register for the IDP/AppPatrol signature service (at least the trial)
before you can use it. See Chapter 4 on page 35.
Table 85 Input Values for IDP Commands
LABEL DESCRIPTION
zone_profile The name of a zone. For the ZyWALL USG 300 and above, use up to 31
characters (a-zA-Z0-9_-). The name cannot start with a number. This value is
case-sensitive.
The ZyWALL USG 100 and 200 models use pre-defined zone names like DMZ,
LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and WAN.
idp_profile The name of an IDP profile. It can consist of alphanumeric characters, the
underscore, and the dash, and it is 1-31 characters long. Spaces are not allowed.
To Next Page
Loading...
