Chapter 5 Interfaces
ZyWALL (ZLD) CLI Reference Guide
68
5.4.1 Cellular Interface Command Examples
This example shows the configuration of a cellular interface named cellular2 for use with a
Sierra Wireless AC850 3G card. It uses only a 3G (or 3.5G) connection, PIN code 1234, an
MTU of 1200 bytes, a description of "This is cellular2” and sets the connection to be nailed-
up.
This second example shows using PUK code 987654321 to unlock a locked SIM card and then
specifying a new PIN code of 4567.
5.5 WLAN Commands
You can install a compatible WLAN card to use the ZyWALL as an access point (AP) for a
wireless network.
5.5.1 WLAN General Commands
Use these commands to configure global settings that apply to all of the wireless LAN
interfaces you create on the WLAN card.
Router(config)# interface cellular1
Router(config-if-cellular)# device AC850
Router(config-if-cellular)# band wcdma
Router(config-if-cellular)# pin 1234
Router(config-if-cellular)# connectivity nail-up
Router(config-if-cellular)# description This is cellular2
Router(config-if-cellular)# mtu 1200
Router(config-if-cellular)# exit
Router(config)# interface cellular2
Router(config-if-cellular)# puk 96385274
Router(config-if-cellular)# pin 4567
Router(config-if-cellular)# exit
Table 32 WLAN General Commands
COMMAND DESCRIPTION
wlan slot_name Specifies the slot the WLAN card is installed in and enters
sub-command mode.
slot_name: The name of the slot where the WLAN card is
installed in the ZyWALL. Use slotx where x equals the
number of the card slot.
[no] activate Turns the wireless device on. The
no command turns it off.
band <b | g | bg> Sets whether wireless clients can connect to the ZyWALL
using IEEE 802.11b, IEEE 802.11g, or both.
channel <wireless_channel | auto> Sets the wireless operating channel.
wireless_channel: Specify the channel number. The
numbers available vary by region.
To Next Page
Loading...
