Chapter 26 Services
ZyWALL (ZLD) CLI Reference Guide
225
26.2.2.1 Service Group Command Examples
The following commands create service ICMP_ECHO, create service group SG1, and add
ICMP_ECHO to SG1.
[no] object-group group_name Adds the specified service group (second
group_name) to the specified service group (first
group_name). The no command removes the
specified service group from the specified service
group.
[no] description description Sets the description to the specified value. The
no
command removes the description.
description: You can use alphanumeric and
()+/:=?!*#@$_%- characters, and it can be up
to 60 characters long.
object-group service rename group_name
group_name
Renames the specified service group from the first
group_name to the second group_name.
Table 131 object-group Commands: Service Groups (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# service-object ICMP_ECHO icmp echo
Router(config)# object-group service SG1
Router(group-service)# service-object ICMP_ECHO
Router(group-service)# exit
Router(config)# show service-object ICMP_ECHO
Object name Protocol Minmum port Maxmum port Ref.
===========================================================================
ICMP_ECHO ICMP 8 8 1
Router(config)# show object-group service SG1
Object/Group name Type Reference
===========================================================================
ICMP_ECHO Object 1
To Next Page
Loading...
