2gig Technologies GC2 - User Codes; Duress User Code Setup; Changing a User Code; Setting the Duress User Code

GC2 Wireless Security System | User Guide
32 Copyright © 2016 Nortek Security & Control
6 Asecondscreenconfirmsthatthe
schedulewasdeleted.TapOk.
User Codes
Changing a User Code
1 AttheUserManagementscreen,tapthe
Userbuttontochangetheusercode.
2 Ensurethatthecurrentusercode
appears.ThentapChangePin.
3 Enteranewfour(4)‐digitusercodeto
useasthePIN.ThentapOk.
4 Toconfirmtheusercode,enterthennew
codeagain.TapOk.
5 Aconfirmationscreenappears,showing
thattheusercodewaschanged.TapOk.
Deleting a User Code
1 TodeleteausercodefromtheUser
Managementscreen,taptheUser
button.
2 TapDelete.
3 Aconfirmationscreenappearstoverify
thatyouwanttodeletetheusercode.If
Ok,tapDeleteUserortapCancelto
returntotheusercodesAccessOption
screen.
4 Aconfirmationscreenappearsdisplaying
theusercodethatwasdeleted.TapOk.
TIP: Youcanchangethemasteruser
code,butyoucannotdeleteit.
Duress User Code Setup
TheDuressCode(UserCode#8)initiatesa
silentalarmforhelpbysecretlysendinga
DuressreporttotheCentralStation.
Usetheduresscodewhensomeoneis
forcingyoutooperateyoursecuritysystem
againstyourwill.Whenyouusetheduress
code,asilentreportisimmediatelysen tto
theCentralStationandtheywilldispatch
help.
Setting the Duress User Code
1 OntheUserManagementscreen,tap
theUser8(Duress)button.
2 Aconfirmationscreenappears:Tap
CreateDuressUser .
3 Enterafour(4)‐digitcodetouseasthe
newduresscode.ThentapOk.
4 Toconfirmtheduresscode,enterthe
codeagainandtapOk.
5 Aconfirmationscreenappears.TapOk.
6 TheUser8editscreenappears.Toreturn
totheUserManagementscreen,tap
Back.