2gig Technologies GC2 - SET DATE AND TIME

GC2 Wireless Security System | User Guide
38 Copyright © 2016 Nortek Security & Control
6 AttheToolbox(2of3)screen,tapClean
Screen.
NOTE: TheDisplayCleaningscreen
appearsfor30seconds.Itshows
thetimeremaining.Thetouch
screenislockedduringthistime.
Whenthetimerexpires,the
systemreturnstotheToolbox
screen.
TOUCH SCREEN CALIBRATION
Tocalibratethedisplay:
1 AttheHomescreen,tapSecurity.
2 AttheSecurityscreen,tapMenu.
3 AttheMenuscreen,tapToolbox.
4 Enteravalidusercodetogainaccessto
theToolbox.
5 AttheToolbox(1of3)screen,tapthe→
arrow.
6 AttheToolbox(2of3)screen,tap
CalibrateTouchScreen.
Thetouchscreendisplaysacrossonthe
screen.Touchthecenterofthecross.
Repeatwiththenext2crossesthat
appear.
7 Whencalibrationhasbeensuccessful,a
completionscreenappears.Tofinishand
returntotheToolboxscreen,tapOk.
SET DATE AND TIME
TheControlPanelhasabuilt‐inclockand
calendar.TheHomescreendisplaysthetime
anddate.Thetimeanddatearealsoused
forthesystemhistoryandeventlogsthat
storedataonsystemevents.
NOTE: Du
ringinstallation,yourinstaller
cansetthesystemtoautomatically
adjustfordaylightsavingtimeifit’s
observedinyourlocation.
NOTE: Theti
meanddateare
automaticallysetthroughthe
cellularradiobytheCentralStation
ifyourControlPanelhasacellular
radioinstalled.
Tose
tthedateandtime:
1 AttheHomescreen,tapSecurity.
2 AttheSecurityscreen,tapMenu.
3 AttheMenuscreen,tapToolbox.
4 AttheToolbox(1of3)screen,tapthe→
arrow.
5 AttheToolbox(2of3)screen,tapSet
DateorSetTime.