Remote Wake-Up 17
Remote Wake-Up
Remote Wake-Up is the ability to remotely power-on a PC
for after-hours administration.
Remote Wake-Up support is enabled by connecting a
Remote Wake-Up cable from the NIC’s Remote Wake-Up
(RWU) connector to a 3-pin Remote Wake-Up connector
on the PC motherboard. See “Connecting the Remote
Wake-Up Cable” in Chapter 2 for instructions.
Remote Wake-Up Cable
A Remote Wake-Up cable is shipped with each NIC that
supports this feature.
To order additional Remote Wake-Up cables, contact 3Com:
■ Toll-free number for the United States and Canada:
1-877-226-4604
■ Toll number for international calls:
1-510-226-4604
Remote Wake-Up Requirements
The following NICs support Remote Wake-Up:
■ 3C905C-TX-M
■ 3C905B-TX
■ 3C905B-TX-M
■ 3C905B-COMBO
■ 3C905B-FX
■ 3C900B-FL
Your PC or server must have a management application
that supports Remote Wake-Up. In addition, the following
items ar required to use Remote Wake-Up.
For 3C905C-TX-M NICs, if your PC is compliant with
PCI 2.2, Remote Wake-Up is automatically enabled
through the PCI bus. The Remote Wake-Up cable is not
required. (See your PC documentation if you are unsure
whether your PC is compliant with PCI 2.2.)
book Page 17 Thursday, July 29, 1999 12:23 PM
To Next Page
Loading...
