Configuring the Managed PC Boot Agent (MBA) 63
Non-BBS BIOS-Compatible PCs
To enable a non-BBS BIOS-compatible PC to boot from the
network using the MBA boot ROM:
1 Make sure that the NIC boot ROM setting is Enabled.
See “Enabling or Disabling the Boot ROM Setting” earlier
in this chapter for instructions.
2 Change the MBA default boot setting from Local
to Network.
To change the default boot setting or any other MBA
configurations, use the MBACFG utility located on the
MBA utility diskette or press Ctrl+Alt+B when the following
message appears:
Initializing MBA. Press Ctrl+Alt+B to
configure...
For more information on using, configuring,
and troubleshooting the MBA boot ROM, see the
Managed PC Boot Agent User Guide, located with
the MBA software on the EtherCD.
book Page 63 Thursday, July 29, 1999 12:23 PM
To Next Page
Loading...
