Inserting the NIC in the PC 27
7 Secure the NIC with the screw you removed earlier.
8 Replace the PC cover and plug in the power cord.
Do not turn on the power to the PC.
The next step is to connect the NIC to the network. Go to
“Connecting the NIC to the Network
.”
1 Remove slot cover
2 Insert NIC
PCI slots
If you want to install the Remote Wake-Up cable, go
to the next section, “Connecting the Remote Wake-Up
Cable” to continue the installation. If you do not want to
connect the cable, continue with step 8.
book Page 27 Thursday, July 29, 1999 12:23 PM
To Next Page
Loading...
Need help?
General
