323D SYSTEMS, INC.
LIFTING
Caution : Moving the printer may affect settings (alignments, calibration...). Contact your 3D Systems-
certied Customer Support Engineer to check the operation of the printer after moving.
When moving the ProX
®
DMP200 system, follow the instructions outlined below :
• The system must only be lifted by authorized people.
• Make sure entire lifting, rigging and supporting structure has been inspected, and is in a good condition.
• The main cabinet can be moved by using a forklift with a load capacity of at least 1500 kg (3307 lbs), with minimum fork
length of 1500 mm (59.05 in.).
• The control/supply cabinet is easily moved as it is equipped with transport wheels.
To Next Page
Loading...
