703D SYSTEMS, INC.
REASONABLY FORESEEABLE MISUSE
The DMP machine must not be used for any purposes other than metal powder sintering.
Do not operate the machine outside the limits of operation of the machine (building volume, supply pressure...).
These are typical examples of machine misuse:
CYCLE DESCRIPTION
Building process
Do not start a job while warning message(s) is (are) still activated (see section "Manufacturing
menu" on page 43).
Do not start a job without cleaning the lens, or at least, controlling its cleanliness.
At anytime
Do not start the lens cleaner blower while the process lter is not connected to the printer.
Do not try to open the front doors without pressing the key button at rst (see section "Machine
preparation" on page 56).
Do not move the carriage while the tamping plate or any other object is present in the
manufacturing chamber.
Do not ll the feeding piston with material without compacting several times. This may result in
bad compacting, thus short feeding hazard during the layerings.
Maintenance
Do not conrm the lens lter replacement warning message without actually replacing the lter.
The level of lter clogging impacts the quality of the sintering process.
To Next Page
Loading...
Need help?
General
