853D SYSTEMS, INC.
6. Dispose of the old element in accordance with all local/regional/national/, state and federal regulations.
WARNING : FLAMMABLE POWDERS.
PLACE THE USED FILTER ELEMENT IN A CLOSED METALLIC CONTAINER IN A ROOM WITH FIRE DETECTION.
7. Clean the lter guard with the use of damp cotton cloth.
8. Assemble the new lter element, and replace it with the lter guard on the machine.
Caution : Make sure to re-use the 2 O-rings (on top and bottom).
Caution : Make sure to t the lter element assembly on the correct position as indicated on the following
gures (removable cap on the top, and centered on the lter guard) .
9. Open the input valve.
10. Close the left side door and the door located below the front doors of the machine.
O-ring
O-ring
Filter guard
Removable cap
Removable cap on the top
Filter element centering: it must be placed on the locating pin of the lter guard.
Locating pin
To Next Page
Loading...
