Operational, Basic, and Advanced Parameters
41-001343-02 REV05 – 07.2014 A-91
Parameter –
sips local certificate
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Allows you to specify the Local Certificate file to use when the phone uses the TLS trans-
port protocol to setup a call.
This parameter is required when configuring TLS (optional for Persistent TLS.)
You can use this parameter in three ways:
• To download no certificates
• To download a certificate from the original configuration server
• To download a certificate from another specified server
To download a specific file, the string value MUST HAVE A FILENAME at the end of the
string. For example:
sips local certificate:ftp://admin:admin!@1.2.3.4:50/path/phonesLocalCert.pem
where “path” is the directory and “phonesLocalCert.pem” is the filename. If you do not
specify a filename, the download fails.
See examples for each below.
Note:
The certificate file must use the format “.pem”. To create specific certificate files to use on
your IP phone, contact Aastra Technical Support.
Format <filename>.pem
Default Value Not Applicable
Range Not Applicable
Example The following example downloads no local certificate file:
sips local certificate:
The following example downloads the local certificate file from the original configuration
server.
sips local certificate: phonesLocalCert.pem
The following example uses FTP to download the firmware file “phonesLocalCert.pem”
(local certificate file) from the “path” directory on server 1.2.3.4 using port 50:
sips local certificate: ftp://admin:admin!@1.2.3.4:50/path/phonesLocalCert.pem
To Next Page
Loading...
