Operational, Basic, and Advanced Parameters
A-92 41-001343-02 REV05 – 07.2014
Parameter –
sips private key
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Allows you to specify a Private Key file to use when the phone uses the TLS transport pro-
tocol to setup a call.
This parameter is required when configuring TLS (optional for Persistent TLS.)
You can use this parameter in three ways:
• To download no private key
• To download a private key from the original configuration server
• To download a private key from another specified server
To download a specific file, the string value MUST HAVE A FILENAME at the end of the
string. For example:
sips private key: ftp://admin:admin!@1.2.3.4:50/path/phonesPrivatekey.pem
where “path” is the directory and “phonesPrivateKey.pem” is the filename. If you do not
specify a filename, the download fails.
See examples for each below.
Note:
The key file must use the format “.pem”. To create specific private key files to use on your IP
phone, contact Aastra Technical Support.
Format <filename>.pem
Default Value Not Applicable
Range Not Applicable
Example The following example downloads no private key file:
sips private key:
The following example downloads the private key file from the original configuration
server.
sips private key: phonesPrivateKey.pem
The following example uses FTP to download the firmware file “phonesPrivateKey.pem”
(private key file) from the “path” directory on server 1.2.3.4 using port 50:
sips private key: ftp://admin:admin!@1.2.3.4:50/path/phonesPrivateKey.pem
To Next Page
Loading...
