Aastra 6730I - Page 770

Softkey/Programmable Key/Keypad Key/Feature Key/Expansion Module Key/Hard Key
A-164 41-001343-02 REV05 – 07.2014
Parameter –
softkeyN states
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Displays the status of the phone when a softkey is pressed. You can enter multiple values
(idle, connected, incoming, outgoing, busy) for the "softkeyN state" parameter.
You must associate the softkeyN state parameter with a specific softkey. In the following
example, the softkeyN states parameter is associated with softkey 12:
softkey12 type: speeddial
softkey12 label: voicemail
softkey12 value *89
softkey12 states: outgoing
Note:
The IP phone idle screen condenses the softkeys. So in the previous example, softkey 12
will appear in position 1 if no other softkeys are set. A softkey type of "empty" does not
display on the idle screen at all.
Format Text
Default Value For softkey type none, flash, phonelock, paging:
All states disabled
For softkey types line, dnd, speeddial, blf, list, dcp, xml, lcr, callforward, blfxfer,
speeddialxfer, speeddialconf, speeddialmwi, directory, filter, callers, redial, conf, xfer,
icom, services, empty:
idle, connected, incoming, outgoing, busy
For softkey type flash:
All states disabled
For softkey type park, sprecode:
connected
For softkey type pickup:
idle, outgoing
For softkey type acd:
idle
Range Valid values are:
idle: The phone is not being used.
connected: The line currently being displayed is in an active call (or the call is on hold)
incoming: The phone is ringing.
outgoing: The user is dialing a number, or the far-end is ringing.
busy: The current line is busy because the line is in use or the line is set as “Do Not Dis-
turb”.
Note:
For softkey type, Pickup, values can be: just idle, just outgoing, or idle outgoing.
Example softkey1 states: idle incoming outgoing
softkey2 states: connected