Parameters 169
96.16 Unit selection Selects the unit of parameters indicating power, temperature
and torque.
0b0000
0b0000…0b1111 Unit selection wo rd . 1 = 1
96.20 Time sync primary
source
Defines the 1st priority external source for synchronization of
the drive’s time and date.
Panel link
Internal No external source selected. 0
Fieldbus A Fieldbus interface A. 3
Embedded FB Embedded fieldbus interface. 6
Panel link Control panel, or Drive composer PC tool connected to the
control panel.
8
Ethernet tool link Drive composer PC tool through an FENA module. 9
96.51 Clear fault and
event logger
Clears all events from the drive’s fault and event logs. 0
0…1 1 = 1
96.100 Change user pass
code
(Visible when user lock is open)
To change the current user pass code, enter a new code into
this parameter as well as 96.101 Confirm user pass code. A
warning will be active until the new pass code is confirmed.
To cancel changing the pass code, close the user lock without
confirming. To close the lock, enter an invalid pass code in
parameter 96.02 Pass code, activate parameter 96.08
Control board boot, or cycle the power.
See also section User lock (page 52).
10000000
10000000…
99999999
New user pass code. -
96.101 Confirm user pass
code
(Visible when user lock is open)
Confirms the new user pass code entered in 96.100 Change
user pass code.
10000000…
99999999
Confirmation of new user pass code. -
No. Name/Value Description Def/FbEq16
Bit Name Information
0 Power unit 0 = kW
1 = hp
1 Reserved
2 Temperature
unit
0 = °C
1 = °F
3 Reserved
4 Torque unit 0 = Nm (N·m)
1 = lbft (lb·ft)
5…15 Reserved
ACQ80 FW.book Page 169 Thursday, February 14, 2019 11:33 AM
To Next Page
Loading...
